kobalttools.com
12
CARE AND MAINTENANCE
r
e
p
o
r
p
e
r
u
s
n
e
o
t
y
l
r
e
p
o
r
p
d
make sure the tool
•
Always use clean, dry, regulated and compressed air when using this item.
•
recommended that up to six drops of pneumatic tool oil (L) be added to the air inlet of the tool
after every 2 hours of continuous use.
•
e
t
a
c
i
r
b
u
l
d
n
a
y
ll
a
c
i
d
o
i
r
e
p
d
e
t
c
e
p
s
n
i
e
b
t
s
u
m
s
l
o
o
t
d
e
t
a
r
e
p
o
-
r
i
A
operation.
•
DO NOT USE TOOL
if any parts are worn or damaged.
•
DO NOT USE TOOL
in freezing conditions.
•
T
ighten all screws and caps frequently. Always keep the magazine of the tool clean and free
of any dirt or debris. The tool should not be stored or stand in temperatures of freezing or below.
If, however, the tool has been in temperatures of freezing or below,
has
CLEARING A JAMMED FASTENER
9
Install the spacer(part 56 shown on parts list of manual) by
tighting 2 screws turning clockwise.(See Figure 9)
Once the jammed fastener(s) have been cleared, connect the air tool to the air supply and test fire
three to five fasteners into a scrap piece
of flooring, making sure that all the jammed fasteners
have been properly cleared and that the tool is firing properly. If fasteners do not fire properly
repeat the clearing a jammed fastener instructions.
Once the fasteners have been removed, attach the nail head
cover (part 24 shown on parts list of manual) and tighten 4
screws by turning clockwise.(See Figure 8)
8
warmed up above freezing for 20-30 minutes before use.
