28
OPERATING INSTRUCTIONS
DEPTH-OF-CUT ADJUSTMENT (Fig. 7)
WARNING:
Always maintain the correct blade-depth
setting.
The correct blade-depth setting for all cuts should not
exceed the thickness of the material being cut by more
than 1/4 in. (6.5 mm).
Greater blade depth will increase the chance of kickback,
and cause the cut to be rough.
1. Remove the battery pack (W) from the saw.
2. Raise the depth-locking lever (M) to release it.
3. Determine the desired depth of cut.
4. Hold the base (JY %!
raise or lower the saw until the indicator mark on
the saw aligns with the desired depth on the depth
scale (N).
5. Lower the depth-locking lever to lock it into position.
ADJUSTING THE CUTTING ANGLE (Fig. 8)
1. Loosen the bevel-locking knob (E), located on the
0°- 50° bevel scale (F) on the base plate (J).
2. Tilt the body of the saw until the required angle is
reached (refer to the 0°- 50° bevel scale).
3. Tighten the bevel-locking knob to secure the saw
and angle.
7
8
E
F
M
N
J
