9
OPERATING INSTRUCTIONS
To Attach Battery Pack
a. Align the raised portion on the battery pack
with the grooves on the bottom of the tool,
then slide the battery pack onto the tool, as
shown.
b. Make sure that the latches on the battery
pack snap into place and the battery pack is
secured to the tool before beginning operation.
NOTICE:
When placing the battery pack on the
tool, be sure that the raised rib on the battery pack
aligns with the groove on the tool and the latches
snap into place properly. Improper assembly of
the battery pack can cause damage to internal
components.
To Detach Battery Pack
a. Press the battery-release buttons to release the battery pack.
b. Pull backward on the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, always remove the battery pack
when the tool is not in use or when carrying the hammer drill at your side.
2. Direction-of-Rotation Selector
(Forward/Center Lock/Reverse)
The direction of bit rotation is reversible and
is controlled by a selector (F) located near the
variable-speed trigger switch (E). With the hammer
drill held in the normal operating position, pointing
away from you:
a. Position the direction-of-rotation selector (F) to
the left of the tool for forward rotation.
b. Position the direction-of-rotation selector to the
right of the tool for reverse rotation.
c. Setting the selector in the center (lock) position
helps reduce the possibility of accidental
starting when not in use.
NOTICE:
To prevent gear damage, always allow the hammer drill to come to a complete stop
before changing the direction of rotation.
NOTICE:
The hammer drill will not run unless the direction-of-rotation selector is engaged fully
to the left or right.
1
Battery-release
button
2
Forward
Reverse
