‘D’
command
Parameters: None
Format:
‘D’
Output:
‘!’ – KDC200 internal flash memory is full or Reading failure
‘@’ – Barcode reading success
Purpose:
Turns the motor on, then turns the laser on and starts scanning. When a barcode is found or if
timeout occurred, it stops the motor and turns off laser.
‘E’
command
Parameters: None
Format:
‘E’
Output:
‘@’ – all the times.
Purpose:
Erases the internal flash memory completely. All scanned data is lost.
Remarks:
Should be issued after the upload commands (‘P’ or ‘p’).
‘F’
command
Parameters: None
Format:
‘F’
Output:
‘@’ – all the times.
Purpose:
Set KDC200 internal options and flags to the factory default setting.
The factory default settings are:
- All symbologies are enabled.
- All options are disabled except
. UPCE_ReturnCheckDigit
. UPCA_ReturnCheckDigit
. EAN8_ReturnCheckDigit
. EAN13_ReturnCheckDigit
