Chirp 3260 Hardware Installation Manual
2-2
2.2
System Clearances
The following image shows the necessary clearances for the Chirp 3260 handles and rear panel connectors. Please
allow sufficient clearance for cable installations with proper bend radius.
For proper cooling and airflow it is recommended that a minimum 1U gap be left directly above the Chirp 3260. The
image below shows the locations of the system cooling fans and air intake slots.
CHIRP 3260 Top Panel Dimensions showing Fan locations
The information contained in this document is proprietary data of Knudsen Engineering Limited. Any disclosure, use, or reproduction of this
information for other than the specified purpose intended is expressly prohibited unless agreed to in writing by Knudsen Engineering Limited.
D101-04965-Rev3
Page 6 of 9
