KNOVA KN RXW-10M3, User Manual

Page: 8 / 40

Fig. 5
7
ASSEMBLE AND ADJUSTMENTS
c
d
Fig. 4
REMOVE GREASE FROM THE SAW TOP
The protective coating on the saw table top and extension
wings prevents rust from forming during shipping and storage.
Remove it by rubbing with a rag dipped in kerosene, mineral
spirits or paint thinner. (Dispose of potentially flammable sol-
vent–soaked rags according to manufacturer’s safety recom-
mendations.) A putty knife, held flat to avoid scratching the
surface, may also be used to scrape off the coating followed
by clean–up with solvent. Avoid rubbing the saw’s painted
surfaces, as many solvent–based products will remove paint.
ASSEMBLE THE EXTENSION WINGS
Attach extension wings using the 6 hex head screws and
lock washers. Make screws only finger tight at first. Use a
straightedge to ensure that wing is level with table from front
to back. Gently tap wing up or down, then tighten screws with
the supplied combination wrench, leaving the center screw
last to be tightened.
Be sure that extension wings are flush with front edge of table
and that the painted ends face out
Level here
Flush here
Fig. 6
CHECK HEELING (PARALLELING) OF THE SAW BLADE
TO THE MITER GAGE GROOVE
See Figures 7 and 8.
DO NOT loosens any screws until you have checked with a
square and made sure adjustments are necessary. Once the
screws are loosened, these items must be reset.
WARNING
Make sure the switch is off, and your saw is
unplugged. Failure to do so could result in accidental
starting, resulting in serious personal injury.
WARNING
The saw blade must be parallel to the miter gauge
groove so the wood does not bind, resulting in kickback.
You could be hit or cut.
Marked tooth
at front
Miter gage
groove
Framing square
Marked tooth
Fig. 7