Fig. Y
1
2
14
OPERATING INSTRUCTIONS
• When transporting the drill
press, the table (1) and
head (2) should always be
locked in position. Refer
to the sections of
“INSTALLING
THE TABLE” and
“INSTALLING
THE HEAD” for details.
• Hold the table and motor
with two people as shown
in Fig. Y and then move
the drill press.
FREE WARNING LABEL
REPLACMENT:
If your warning labels
become illegible or are
missing, call: 01-800-70
KNOVA(56682) for a
free replacement.
MAINTENANCE
WARNING
For your own safety, turn the switch off and remove
the plug from the power source outlet before
maintaining or lubricating your drill press.
GENERAL MAINTENANCE
Frequently blow out dust and grit that accumulates in the
motor housing using compressed air.
A coat of automotive paste wax applied to the table and
column will help to keep the surface clean.
WARNING
ALWAYS use safety glasses. Everyday eyeglasses
are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty.
ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
WARNING
To avoid shock or fire hazard, if the power lead is
worn or cut in any way, replace it immediately.
LUBRICATION
Ball bearings in the drill press are packed with grease at
the factory and require no further lubrication.
Use only mild soap and a damp cloth to clean the tool. Never
let any liquid get inside the tool; never immerse any part of
the tool into a liquid.
IMPORTANT:
To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those listed
in this manual) should be performed by authorized service
centers or other qualified service organizations, always using
identical replacement parts.
To clean cast iron parts of rust, you will need the following
materials (not supplied): scouring pad, spray lubricant, can of
degreaser. Apply the spray lubricant and polish with surface
with the scouring pad. Degrease the surface, then apply
the protective product as an automotive paste wax.
Summary of Contents for KN DP-2000N
