©
KNOP
Elektronik A/S
Fabriksvej 20
DK-7600 Struer
knop.dk
+45 97840444
3
Possible applications for CT901-BED:
CT901-BED can be used as a bedside monitor, giving an alarm if the user does not return to bed within a preset time.
CT901-BED can also be switched on when the user leaves the bed, to reduce the risk of falls when it is dark in the
room. If you want it to light up in the hallway or in the toilet, you can connect up to 5 CT901-BEDs. LS901, which are
lit together with the CT901-BED.
CT901-BED has a relay output that is activated in case of an alarm and provides a connection to the existing alarm
system.
Quick guide for connecting the CT901-BED
1.
Place the bed mat in the bed and connect it to TX901 transmitter.
Open the screw on the back of TX901 and carefully tighten the cap to insert the batteries.
2.
Place CT901R control unit in a wall socket so that it lights up.
3.
Connect the relay cable to the control unit and to the existing alarm system.
Points 4 to 8 are factory set, if the units are purchased in a set (CT901-BED)
4.
Code TX901 with the control unit by entering the main menu (hold both arrow buttons for 3 sec)
5.
Select Main Menu -> Transmitters -> Learn new then press Ent
6.
When the display shows "Activate new transmitter" press the bed mat
7.
Then decide how long the person can be out of bed before the alarm is sent.
This is set under "Bed, timer" 0-99 minutes. (Set to 0 minutes from factory)
8.
If you want the bed alarm to light up when the person gets up, set this under "Light, always"
(Set to "No light" from factory)
9.
Now the bed frame is ready to use
CT901-BED consists of:
•
CT901R with relay output and light.
•
TX901, transmitter for bed mat.
•
Bed mat, D4106011A_3.5jack, with 3m cord and 3.5mm plug.
•
Relay cable, MK204, 3m, 3.5mm to 6.3mm jack.
See Getting started and setting up the CT901R on the next page.
See also TX901 User Manual.
