Knoll Tone Electric, Assembly Instructions Manual

Page: 11 / 12

11
07.17
ASSEMBLY INSTRUCTIONS
3. Table moving in one direc on only
3.1. Only running down in slow speed:
‐ The table is in homing mode. To allow the table to complete the homing cycle, drive all the way down to lowest posi on to
complete the homing cycle.
3.2. Only able to drive up or only down, but in normal speed:
‐ Ini ate a new homing cycle by holding the up and down bu ons on the hand control pressed for 8 seconds. Drive the table all the
way down to lowest posi on to complete the homing cycle.
3.2.1. S ll no func on:
‐ Replace hand control.
3.2.2. S ll no func on:
‐ Replace the column.
4. Table only running a short while and then stopping
4.1. The table stops and back o ff :
‐ The table has detected a collision. Check for something blocking the movement, cables, furniture or other objects.
4.1.1. If nothing is blocking the movement of the table and the symptom persists:
‐ Replace the column.
4.2. Only run for 2 seconds:
‐ Table might be overloaded, remove weight from table top
4.2.1. Green light on power supply OK?
‐ If not, replace power supply.
4.2.2. S ll no func on:
‐ Replace the column.
4.3. Only running for 20 seconds or more:
‐ Table might be overhea ng, wait 9 minutes and try again
.
5. Table not moving in sync
5.1. Only one motor moving:
‐ Disconnect from power, then reconnect all cables.
5.2. One motor running uncontrolled and other motor just running 2 inches up or down:
‐ Replace the column.
5.3. Table moving up and down normally but table top not parallel to fl oor:
‐ Ini ate a new homing cycle by holding the up and down bu ons pressed at the same me for 8 seconds. Drive the table all
the way down to lowest posi on to complete the homing cycle.
6. Table not able to reach top or bo om posi on
6.1. Table stops above bo om posi on / not reaching bo om posi on:
‐ Ini ate a new homing cycle by holding the up and down bu ons pressed at the same me for 8 seconds. Drive the table all
the way down to lowest posi on to complete the homing cycle.
6.1.1. Failure to reach lowest posi on during homing cycle:
‐ Replace the column.
6.2. Table not reaching top posi on:
‐ Ini ate a new homing cycle by holding the up and down bu ons pressed at the same me for 8 seconds. Drive the table all
the way down to lowest posi on to complete the homing cycle.
6.2.1. S ll not reaching top posi on:
‐ Replace the column.
*) The motor duty cycle is rated 10% at a nominal load of 176 lbs. E.g. if the motor runs a 1 minute cycle, allow 9 minutes for a complete
cool o ff . If the motor is engaged during the cool o ff period the duty cycle will be reduced un l the full cool o ff period is reached.
68
00
46
86
‐
H
©
ROL
|
Ergo