0900511 Rev: E (06/05)
Page 7 of 20
•
Continued
*** DISPENSER ***
MEMORY FUNCTIONS
1
This menu selection is used to load factory default settings:
– Unit of measure is set to US
– Flush time is set to 10 seconds / drain after set to 2 seconds
– Simultaneous pump setting is turned OFF
– All user passwords are set to zero / user names are reset
– Formula access is set to enable for all users on all formulas
– Report name is cleared (blanked out)
– Chemical names and formula names are reset
– Shift start times are reset: 1 = 06:00 / 2 = 11:00 / 3 = 17:00
– Operating zone is set for 00:00 to 24:00
– Maintenance schedule dates are set to zero
Press YES to begin loading factory defaults (also known as
“clearing the setup“) or press NO to move on to the next menu
selection without loading factory defaults.
LOAD FACTORY DEFAULTS ?
PRESS: YES OR NO
NO
YES
You are then asked if you really do want to use this
command. Press YES if you are sure, or press NO to
move on to the next menu selection without loading.
This message indicates that the clearing
process is active (factory defaults are being
loaded at this point). When the process is
complete, the next menu item will appear.
CLEARING SETUP
*** PLEASE STAND BY ***
ARE YOU SURE ?
PRESS: YES OR NO
YES
NO
GO TO NEXT PAGE
This menu selection is used to zero out the batch count (this is the
digital counter that appears on the screen when pressing the
BATCH COUNT button on the control panel). Press YES to begin
clearing, or press NO to move on to the next menu selection
without clearing.
CLEAR BATCH COUNT ?
PRESS: YES OR NO
NO
YES
This message indicates that the clearing process is
active. When the process is complete, the next menu
item will appear.
CLEARING BATCH COUNT
