Page 16
Assembly Instructions
knightgroup.co.nz
Changing the desktop height displayed
The function enables you to change the height shows on the display based on the actual measurement,
especially when you need to calculate the height including the thickness of the desktop.
1.
Keep pressing the “M” key for 10 seconds till the display shows alternately as “Ur” and
“oFF”.
End
2.
Press UP key till the display shows alternately as “End” and original height.
3.
Changing the height by pressing “1” key to adjust the first numbers, “2” key to adjust
second number, and “3” key to adjust third number.
( for metric, please note that the unit is “mm” during this procedure)
4.
Press “M” key, the height has been changed to defined digit.
INFO
During the adjustment procedure, every time you press the “1”, “2” or “3” key, the corresponding number will
increase by 1.
Reset to Factory Setting
With this function, you can make the control system to factory setting, including memory position, High and
Low limit position, height displayed, etc.
1.
Keep pressing the “M” key for 15 seconds till the display flash as “FAC” .
2.
Press “M”, and the control system has been reset to factory settings.
When the control system is reset to factory settings, as there is no High and Low limit position previously set,
this may lead to minor or moderate injury through crushing. Ensure that no persons or objects are in the
desk’s range of motion.
Agile Pro
Electric 3 Column Double Sided Desk
Summary of Contents for Agile Pro
Page 2: ......
Page 20: ...knightgroup co nz ...