KNEGT 404G2 Series, Operation Manual

Page: 66 / 105

404G2
SERIES TRACTOR OPERATION MANUAL
64
5.4.2 Tractor maintenance during storage
1. During the storage, check and protect the tractor from rust, corrosion, deterioration
and deformation every month.
2. Start the tractor every 3 month, and run it at a low speed for 20 to 30 minutes,
check if there is somewhere abnormal. Before start the engine, follow the request to
add in coolant, diesel, oil and lubricant.
3. Check the condition of the accumulator. It’s better to charge the battery every
month for it will discharge when not be used.
5.4.3 Preparation after Storage
1. Remove the waterproof canvas, clean the tractor.
2. According to the request to fill with coolant, diesel, oil and lubricant.
3. Check the tire pressure and charge if it is not sufficient.
4. Check and charge the accumulator.
5. Check and tighten every external bolts and nuts, especially the bolts on the rear
wheel hub, flywheel housing and clutch housing and so on. Check the condition of
the pipeline and electrical facility, clear the problem if find.
6. Operate the tractor as chapter 4 required, if there is any problem, clear it
immediately.
Important
：
Refer to manual of engine to get information about the engine’s
moving from storage.