KNEGT 304G2, Operation Manual

Page: 43 / 103

304G2
SERIES TRACTOR OPERATION MANUAL
41
4.2.4 Start the Tractor
1. Loose the park brake system and press the horn then check the surroundings.
2. Depress the clutch pedal to the end, shift to a
proper gear. If it fails, then loose the clutch pedal,
and do these procedures again.
3.
Step up the tractor, and loose the clutch pedal
slowly at the same time.
4.2.5 Driving the Tractor
1.The tractor’s driving
(1) The choice of gear. This series of tractors has eight
forward gears and eight backward gears. The selection
of the tractor
’
s gear should based on regional
geology 、 climate
and work type. The
proper selection of
gear, can achieve
maximum
productivity and
economical
efficiency, and can
prolong the service
life of the tractor.
The tractor should
not be often overload, The tractor work at 80% of the maximum power, let the tractor
engine has a certain power reserves.
a) The basic gears of work are :Plough often use low Ⅲ gear, low Ⅵ gear, high Ⅰ
gear; rotary tillage often use low Ⅰ gear, low Ⅱ gear, traction operations often use low
Ⅲ gear, low Ⅵ gear, high Ⅰ gear, high Ⅱ gear; transport operations often use high
Ⅱ gear, high Ⅲ gear, high Ⅵ gear. Spindle gear , the main gear, high and low gear
as shown in fig 4-12.
Range Shift Lever
See.fig.4-1No.3
Shuttle Shift Lever
See.fig.4-1No.8
Gear shift lever
See.fig.4-1No.15
Fig.4-12
Fig.4-11
A. Park brake control lever
B. Brake pedals