5
1.1 Intended purpose
The HV 150 hand knife grinding attachment is used to grind hand knives. This attachment is
meant to be installed onto KNECHT grinding machines of the USK 160 S series.
1.2 Mounting the HV 150 hand knife grinding attachment
1.2.1 Mounting the CBN grinding wheels
Mount two CBN grinding wheels in order to grind
hand knives using the HV 150.
To do so, loosen the star handles (1-1/1) on the
left-hand side of the machine and remove the
protection hood. Then remove the finned grinding
wheel.
Use a spanner wrench (SW 22) to loosen the nut
(1-2/1) of the grinding spindle.
Loosen = turn left (in the direction of rotation)
Tighten = turn right (against the direction of
rotation)
Pull the finned grinding wheel off the grinding
spindle.
NOTICE
If the grinding spindle turns too, counter it
with a spanner wrench (SW 10) on the end of
the shaft.
1. Operation
Figure 1-2
Removing the finned grinding wheel
1
Figure 1-1
Removing the protection hood
1
1
