42
Operation
BlueShadow Pump 80P Instructions V7685
5.9.2 Run link
After the link has been completed, the display switches to the end mode,
indicated by the letter E at the upper left corner.
1.
Go to the main menu.
2.
Navigate to
Link/Program in the lower left display line and choose Link
with the vertical arrow key .
3.
Enter a link number.
4.
The pump status switches to the status hold (H) and starts pumping
with the initial flow rate of the program.
5.
Navigate to the pump status and press the up arrow key to set the
pump into a run status (R).
6.
The link will start running the programs.
7.
Use the down arrow key with the cursor on the pump status to pau-
se the execution of the link (Status: H).
8.
Press the up arrow key to resume the run (Status: R).
5.9.3 Delete link
Process
Figure
1.
Select the menu
Link and choose the link 00.
2.
Activate the numeric pad by pressing and
enter the desired program number you wish to
delete.
3.
Confirm with
or deny with .
Procedure