B.
Loosen the tilt adjusting screw and adjust door mount brackets until they are parallel with the
front of the cabinet according to the diagram shown.
(Fig. 6)
Once parallel, retighten screws.
4. Determine Door Bracket Position
A.
Measure the cabinet opening width.
(Fig. 7)
Refer to chart
(Fig. 1)
to determine extension
bracket orientation. If brackets are not required, skip to step 5.
B.
Insert one #10 - 24 x 1/4" pan head machine screw in each round hole of the extension
bracket.
(Fig. 8)
Turn 2 to 3 times.
C.
Extend sliding base assembly out of the cabinet interior to a comfortable working position.
Align the pan head screws on the extension bracket with the keyholes in the door bracket.
Insert through keyhole and push downward until the pan head screws are fully seated. If
necessary, loosen the pan head screws slightly to verify screws are fully seated.
Tighten screws.
(Fig. 8)
D.
Ensure door brackets do not interfere with cabinet opening and set back is in desired location.
If necessary, adjust sliding base assembly accordingly.
5. Install Cabinet Door to Door Bracket
A.
Ensure that the chassis in the fully closed position. Peel protective cover from tape on the
brackets. Line up the cabinet door in desired position ensuring that it is level with any cabinet
doors on either side. Also ensure that the spacing between the door and any drawer above is
even with the spacing on your other cabinets.
(Fig. 9)
Fig. 6
Fig. 8
Fig. 7
Fig. 9
