KMC Controls
P.O. Box 497
19476 Industrial Drive
New Paris, IN 46553
574.831.5250
www.kmccontrols.com
221-019-01C
Adjustments and Calibration Continued
To Adjust Reset Start:
Thermostat Reset Start Point is factory Set at 8 psi.
1. Remove cap on Port “G” port
2. Connect to a 0– 30 psi gauge
3. Apply desired thermostat start point pressure to
Port “T”
3. Adjust “Reset Start” until gauge pressure increases
slightly (0.3 psig maximum).
4. Disconnect gauge and replace Port “G” cap
To Adjust Reset Span:
Thermostat Reset Span is factory set at 5 psig.
1. Remove Port “G” cap
2. Connect accurate 0–30 psi gauge.
3. Set thermostat for a Port “T” pressure of 15–30 psig.
4. Adjust “Reset Span” until gage pressure indicates the
desired span. This is total span pressure, not ending
pressure.
NOTE
: An increase or decease of a 5 psig reset span will directly affect the differential pressure range.
Increasing the span to 7 psi will double the range, decreasing the span to 3.5 psi will halve the range.
5. Disconnect gauge and replace Port “G” cap
To Adjust Minimum and Maximum Limits:
1. Disconnect thermostat from Port “T” port
2 Adjust LO STAT
∆
P:
For DA cooling or RA heating applications, adjust “LO STAT
∆
P for minimum flow.
For RA cooling or DA heating applications, adjust “LO STAT
∆
P” for maximum flow.
3. Set thermostat for a Port “T” pressure of 15–30 psig.
4. Adjust HI STAT
∆
P:
For DA cooling or RA heating applications, adjust “HI STAT
∆
P” for maximum flow.
For RA cooling or DA heating applications, adjust “HI STAT
∆
P” for minimum flow.
NOTE
:For maximum accuracy/repeatability, repeat/check minimum and maximum limit adjustments
twice. “LO STAT
∆
P” must be adjusted first followed by “HI STAT
∆
P” adjustment. “LO STAT
∆
P”
adjustments affect “HI STAT
∆
P” settings.
Maintenance
No routine maintenance is required.
Each component is designed and manufactured for
reliability and performance. Careful installation and
use will ensure long term dependability.
