Page 10 of 32
Extension Cords
•
USE A PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using
an extension cord, be sure to use one heavy enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage, resulting in loss of power and cause overheating.
•
Be sure your extension cord is properly wired and in good condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it. Protect your extension cords
from sharp objects, excessive heat and damp or wet areas.
•
Grounded tools require a 3-wire extension cord. Double Insulated tools can use either a 2- or 3-wire
extension cord.
•
As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using
extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power
and possible tool damage.
•
The smaller the gauge number of the wire, the greater the capacity of the cord. For example, a 14-gauge
cord can carry a higher current than a 16-gauge cord. Minimum extension cord wire size is shown in the
following table:
Minimum Wire Size Of Extension Cords
Nameplate AMPS
Cord Length
25'
50'
100'
150'
0-6
18 AWG
16 AWG
16 AWG
14 AWG
6-10
18 AWG
16 AWG
14 AWG
12 AWG
10-12
16 AWG
16 AWG
14 AWG
12 AWG
12-16
14 AWG
12 AWG
NOT RECOMMENDED
•
When using more than one extension cord to make up the total length, make sure each cord contains at
least the minimum wire size required.
•
If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum
to determine the required minimum cord size.
•
If you are using an extension cord outdoors, make sure it is marked with the suffix
W-A
(
W
in Canada) to
indicate it is acceptable for outdoor use.
•
Make sure your extension cord is properly wired and in good electrical condition. Always replace a
damaged extension cord or have it repaired by a qualified electrician before using it.
•
Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Summary of Contents for 49671
Page 21: ...Page 21 of 32 Wiring Diagram...
