Suspension Arm Systems Independant
100
Revision 1
WARNING
Risk of death by electrocution!
Insufficiently tightened fastening elements can lead to failure of the swivel stop. Moreover,
supply cables could loosen:
•
Tighten the M16 setscrew or M20 setscrew to 40 Nm.
Check that the swivel stop is working properly:
•
The range of rotation of the extension arm
,
must be limited to less than 360°.
To modify an installed ball stop , see section 8.1.2 “Removing the Swivel Stop”, page 100.
8.1.2
Removing the Swivel Stop
Fig. 8-6:
Removing the swivel stop
•
Pay attention to the assignment and size of
the setscrew and ball stop for the
different versions of the suspension arm
system, see “Versions”, page 97.
•
Unscrew the setscrew from the
threaded hole .
•
Rotate the extension arm
,
until the
ball stop becomes visible in the
threaded hole.
•
Use a telescopic magnet pick-up tool set to
guide 1 ball stop out of the threaded
hole and store it in a safe place.
