For concrete or brick walls, level wall plate and mark the hole locations.
5.
Check the bubble level. If the bubble is centered between the lines, it means that the wall
plate is correctly positioned on the surface.
Proceed to drill the pilot holes using a drill bit, as illustrated.
For concrete or brick walls, insert the anchors making sure they are seated flush with the
surface.
Insert lag bolts and washers, and drive them firmly into the wall.
6.
7.
8.
9.
5. Final assembly
The flat panel must be lifted carefully by two people in order to attach it to the wall mount
you just installed
Hang both arms by aligning the top and bottom hooks on the horizontal rails of the mount.
1.
2.
Lift the tab of each arm and insert a threaded fastener to secure the display onto the wall,
as shown in the figure below.
3.
Summary of Contents for KPM-955
Page 7: ......
