10
Tech Support:
1-800-KLIPSCH
Step 3:
Test fit your LightSpeaker
®
5.
Your LightSpeaker
®
5 is designed to fit directly into most
5“ (R30) and 6“ (R40) down light cans by simply removing
the existing light and, in the same manner as a light bulb,
re-installing your LightSpeaker
®
5 in its place. You may
simply test fit your LightSpeaker
®
5.
If your LightSpeaker
®
5 fits directly into your recessed
lighting fixture without any modifications you can skip
forward to
Step 6
.
If your LightSpeaker
®
5 does not fit either because the
trim ring/reflector opening is too small or the lighting
fixture is not set deep enough, please go to www.klipsch.
com or refer to your Complete System Manual.
Step 4:
Installing the trim ring.
Your LightSpeaker
®
5 comes with their own integrated
trim ring. There are two different sizes. Choose
your trim ring based on either A or B below and place
the LightSpeaker
®
5 trim ring over the back of the
LightSpeaker
®
5. Be sure the finished side is facing out.
Upon completion of the install, this trim ring should fit
snuggly and uniformly to the ceiling and should also seat
properly around the entire edge of your LightSpeaker
®
5.
A)
The thicker trim ring will be used when your
LightSpeaker
®
5 is installed into a 6” lighting fixture.
