Klimawent
– the warranty of highest quality at attractive price
25.01.2021
Ozone generator KILLVIR-48
5 of 12
! WARNING
The device must be connected to a 230 V, 50 Hz earthed socket.
OPERATION
The operation of the
KILLVIR-48
ozone generator consists in turning the device on and off and controlling the
working time – see Picture 1 Control panel.
The control panel includes a socket for connecting the power cord with grounding, an illuminated
O / I
switch,
a display with operating time control buttons and a warning lamp
"DISINFECTION – DO NOT ENTER"
. Before
starting, check that the power cord is not damaged.
Picture 1 Control panel
Procedure
Installation
A.
Place the device as high as possible and in the centre of the room.
B.
Before starting, check that the power cord is not damaged.
NOTICE
Ozone is a gas heavier than air and it falls.
Turning on the device
A.
Plug the power cord into the power socket of the device.
! WARNING
The device must be connected to a 230 V, 50 Hz earthed socket.
B.
Turn the
"POWER SWITCH"
switch to position
I
. The switch will be illuminated red.
C.
Set the ozonation time using the
+
and
–
buttons according to the room volume - see - Table 1
Approximate ozonation times.
D.
Press the
START
button to start ozonation. The
"DISINFECTION – DO NOT ENTER"
warning light will
illuminate. The dot in the lower right corner will flash on the display.
E.
Leave the room – see Note 1 Warning regarding ozonation.