X3-KIT
Installation and Operation Manual
PG 33/40
REV: BETA (4/25/2019)
8.9.8.
On bench, connect remaining amount of supplied 1/4” Air Tubing to Air Fitting on Air Horn Solenoid,
then install Air Horn Driver to Bracket using
H1, H1, H3 & H4. Loosely tighten hardware, as
shown below.
Route 1/4” Air Tubing across Bracket, as desired.
NOTE: It may be necessary to reconnect Trumpets to Air Horn Driver before installing hardware.
Figure 29
–
Installing Air Horn Driver with Tubing attached, Exploded View
8.9.9.
With Trumpets and Air Horn Driver connected,
final torque all fasteners
, as shown per order below.
NOTE: position/slide X3-301 Bracket, as necessary to ensure maximum clearance around springs.
Figure 30
–
Final tightening of Air Horn Brackets and Air Horn
H2 (2)
H1 (2)
H3 (2)
Driver
H4 (2)
Air Tubing
pre-connected
3
2
4
1
Slide X3-302
Support until tight
against Trumpets
