infirm persons without supervision.
Young children should be supervised to ensure that they do
not play with the appliance.
The premises must have sufficient ventilation when the
kitchen hood is used at the same time as other apparatuses
fuelled by gas or other fuels.
The sucked air must not be conveyed in a conduit used for
discharging fumes produced by apparatuses fuelled by gas
or other fuels.
Cooking food on the flame under the hood is severely
prohibited.
The use of open flame damages the filters and can cause
a fire; it must therefore be avoided in any case.
Frying must be carried out under control in order to prevent
overheated oil catching fire.
Keep strictly to the regulations envisaged by the competent
local authority as far as the technical and safety measures
to adopt for discharging fumes are concerned.
The hood is to be cleaned frequently both internally and
externally.
Failure to observe the regulations about cleaning the hood
and substituting and cleaning the filters can lead to the risk
of fire.
Any responsibility is declined for possible
inconveniences, damage or fire caused to the apparatus
deriving from failure to observe the instructions
shown in this manual.
Installation - Fig. 5
Consult the designs in the front pages referenced in the text
by alphabet letters. Closely follow the instructions set
out in this manual. All responsibility, for any damages
or fires caused by not complying with the instructions in this
manual, are the responsibility of the user.
The minimum distance between the supporting surface for
the cooking vessels on the hob and the lowest part of the
range hood must be not less than 40cm from electric cookers
and 65cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify a
greater distance, this must be adhered to.
The rangehood is supplied in the FILTERING version and
is used without an extracted fumes discharger conduit .
Fumes and steam are recycled through the F deflector (11F).
If you intend using the product in the SUCTION version, it
is necessary to have an evacuation conduit going from the
upper B exit to the extraction hole towards the exterior.
In this case a connection ring (11A) has to be installed on
the B extraction hole and the carbon filter removed.
A telescopic flue is available (as an accessory).
Preliminary information for installation of the
rangehood
Expansion wall plugs are provided to secure the rangehood
to most types of walls/ceilings. However, a qualified
technician must verify suitability of the materials in accordance
with the type of wall/ceiling. The wall/ceiling must be strong
enough to take the weight of the rangehood.
Do not tile, grout or silicone this appliance to the wall.
Surface mounting only.
In the case of the presence of panels and/or walls and/or
lateral wall units check that there is sufficient space to install
the rangehood and that access to the command panel is
e a s y .
Only for some models
An aesthetic flue can be purchased as an optional accessory.
Check with the assistance centre whether the model in your
possession envisages this possibility.
We advise installing the rangehood after having purchased
the flue to check with certainty the most suitable installation.
During electrical connection ensure the power supply is
disconnected at the domestic main switch.
•
Trace a centre line on the wall to facilitate the montage
(1), position the hole template so that the middle line
printed on it corresponds to the centre line previously
drawn and that the lower side of the grill corresponds to
the lower part of the rangehood once mounted (2).
•
Make two holes with the 8 mm Ø drill and fix the support
bracket with two dowels and wall screws (3).
•
Open the steam screen and remove the grease filter (see
relative paragraph).
•
Hang up the rangehood (4), adjust its position (5-6) and
mark 1 point from the inside of the rangehood for the
definitive fixing (7). Remove the rangehood and make
a Ø 8 mm hole with the drill (8), insert the wall dowel and
hang the rangehood up again and fix it definitively with
1 screw (9).
•
Connect the electricity (10), but leave the rangehood
disconnected from the general electric panel of the
house.
•
Install the supplied flange (11A –suction version– also
install a discharge tube of suitable dimensions) or the
deflector (11F – filtering version).
•
Mount the grease filter and close the steam screen.
Attention! If the rangehood is to be used in the suction
version, remove, if supplied with the kit, the carbon filter
and the fixing rods (on the back of the grease filter – see
relative paragraph).
If the rangehood is to be used in the filtering version,
check that the carbon filter is already mounted on the
back of the grease filter or, in its absence, purchase it
and install it.
Electrical connection
The electrical tension must correspond to the tension noted
on the label placed inside the cooker hood. Connect the
electrical plug, where provided, to an easily accessible
outlet in conformity with local standards in force. Where an
electrical plug is not provided (for direct connection to
electrical network) or is not easily accessible, place a
standards approved bipolar switch that provide full
disconnection under overvoltage category III conditions, in
accordance with the wiring rules.
Attention: substituting the supply cable must be carried out
by the authorised technical assistance service.
INSTRUCTION ON MOUNTING AND USE
