INSTRUCTION ON MOUNTING AND USE
Description of the rangehood - Fig. 1
1 Control panel
2 Grease filter
3 Grease filter release handle
4 Halogen lamp
5 Vapour screen
6 Air outlet
7 Telescopic flue (optional)
Operation
Description of control panel and hood operation
A. on/off light switch
B. on/off aspiration switch and minimum power
selection
B+C. medium power selection aspiration switch
B+C+D. maximum power selection aspiration
s w i t c h
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the rangehood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
Maintenance
Prior to any maintenance operation ensure that the rangehood
is disconnected from the power supply.
Cleaning
The rangehood should be cleaned regularly internally and
externally.
For cleaning use a cloth moistened with denatured alcohol
or neutral liquid detergents. Avoid abrasive detergents.
W a r n i n g :
Failure to carry out the basic standards of the cleaning of the
rangehood and replacement of the filters may cause fire
risks.
Therefore we recommend oserving these instructions.
Vapour screen
The vapour screen must always be left closed and opened
only for maintenance (e.g. cleaning or changing filters).
Opening - Fig. 1:
Press the lower part of the vapour screen firmly and pull it
forward.
C l o s i n g :
Accompany the vapour screen downwards and press
firmly.
Grease filter
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may
discolour slightly, but this does not affect its filtering capacity.
Removing the grease filters - Fig. 2
Open the steam screen.
Pull the handle downwards and extract the filter.
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
The charcoal filter can be washed once every two months
using hot water and a suitable detergent, or in a dishwasher
at 65°C (if the dishwasher is used, select the full cycle
function and leave dishes out).
Eliminate excess water without damaging the filter, then
remove the mattress located inside the plastic frame and put
it in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years and when the cloth is
damaged.
•
Montage - Fig. 3
Open the steam screen and remove the grease filter.
Install the carbon filter on the back of the grease filter and
fix with two rods.
Attention! The rods are included in the carbon filter
packing and not on the rangehood.
•
To dismantle the filter act in the reverse manner.
Replacing lamps - Fig. 4
Firstly check that the lamps are well cooled prior to replacing
them.
Access the light compartment – extract the guard by levering
it off with a small screwdriver or similar tool.
Replace the damaged light bulb.
Only use halogen bulbs of 20W max (G4), making sure you
do not touch them with your hands.
Close the lamp cover (it will snap shut).
If the lights do not work, make sure that the lamps are
fitted properly into their housings before you call for
technical assistance.
Caution
Never use the hood without the grill mounted!
The hood must NEVER be used as a support unless
expressly indicated.
The appliance is not intended for use by young children or
D
C
B
A
