Kleenmaid LTK95A, Installation Manual

Page: 15 / 22

Installation
13
802116 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Moving Unit to a New Location
To prevent damage while moving the unit, the
shipping materials MUST BE reinstalled.
Reinstallation of Shipping Materials
Disconnect washer from electrical supply.
Remove front access panel by removing two screws.
Place the shock sleeves on all four shock absorbers.
Refer to
Figure 14 .
Insert hooked end of shipping brace into the open slot
of the motor mount. Attach with bolts and lockwashers.
Refer to
Figure 14 .
Reinstall front access panel.
Figure 14
Refer to step 5 for proper procedures whenever the
unit is moved.
Electrical Requirements
(240 Volt, 50 Hertz with 3-Prong Earthing Plug)
NOTE: The wiring diagram is located in the
control hood.
Figure 15
The washer is designed to be operated on a separate
branch, polarized, three-wire, effectively earthed,
240 Volt, 50 Hertz, AC (alternating current) circuit
protected by a
10 Ampere fuse , equivalent fusetron or
circuit breaker.
The three-prong earthing plug on the power cord
should be plugged directly into a polarized three-slot
effectively earthed receptacle rated 240 Volts AC
(alternating current) 10 Amps. Refer to
Figure 16 to
determine correct polarity of the wall receptacle.
H336I
1 Shock Sleeves
2 Motor Mount
3 Bolts and Lockwashers
4 Hooked End of Shipping Brace
2
1
4
3
D009I
To reduce the risk of fire, electric shock,
serious injury or death, all wiring and
earthing MUST abide with local electrical
codes. It is the customer’s responsibility to
have the wiring and fuses checked by a
qualified electrician to make sure the
laundry room has adequate electrical power
to operate the washer.
W246
WARNING
DO NOT OVERLOAD
CIRCUITS
DO NOT USE AN
ADAPTER
DO NOT USE AN
EXTENSION CORD