O P E R AT I O N
Open the door.
Load clothes loosely into the drum.
Load sheets first, starting with one corner.
Close the door.
Dry your hands.
Check that the timer is in the ‘0’ p o s i t i o n .
Plug in the machine.
Select correct heat position (see programme chart on control panel for recommendations).
Set the timer to the required time setting (see programme chart on control panel for
r e c o m m e n d a t i o n s ) .
The drum will begin rotating. Reversing drum models will stop every few minutes to rotate in the
reverse direction for a short time.
Should the clothes become dry before the cycle has finished, or if an excessive programme time
has been selected, the drum will continue to rotate while the thermostat will automatically switch
the heater off to prevent over-drying and save energy.
There is an automatic 12 minute cool down period at the end of every cycle, during which the heater
is switched off. This helps to minimise creasing.
NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM.
When drying large items such as sheets, we suggest you periodically stop the dryer to
redistribute the load.
To stop the machine during the middle of the programme simply open the door; the drum will
stop rotating automatically and restart when you close the door.
To lengthen or shorten a timed programme, reset the timer knob.
AFTER REMOVING THE DRIED CLOTHES:
ALWAYS CLEAN THE FILTER.
Failure to do so could cause the safety cut-out to operate.
–
Pull the filter upwards and away from the appliance.
–
Remove any threads or fluff by hand or with a soft brush.
–
Slide the filter back.
–
Wash the filter occasionally in detergent solution using a soft
brush to remove small particles.
