Instructions for use, installation and connection
23
Troubleshooting guide
Any unskilled attempt to repair the appliance is
extremely dangerous as it might cause electric
shock and short circuit. To avoid such injuries any
repairs may be performed only by qualified
personnel, or after sales service.
However, there are some minor faults which may
be easily removed by the user, in accordance
with the instructions that follow.
Important!
If the malfunction of the appliance was caused by
the improper use, the service visit during the
warranty period is not free of charge.
Following are some simple advice how to repair
minor faults:
Program clock indicates faulty
values or switches on and off
intermittently…
Switch the cooker off, disconnect it from the
mains for a few minutes (unlock the fuse or
switch off the main switch), then reconnect it to
the mains and set the correct daily time.
Program clock display is flashing…
There was a power failure, or the cooker had
been connected to the mains for the first time. All
settings are erased. Set the correct time of day to
be able to activate the oven. After operating in
automatic mode, the oven switches off, the
display indicates time, and the beep is heard.
Take the food from the oven, set the temperature
selection knob and the mode knob into their
original positions. Select the "Manual mode", and
use the oven in a conventional mode (without
programming).
Signal lamp does not turn on....
•
are all the required switches properly activated?
•
is the mains power fuse burned?
•
is the temperature regulator properly set?
Fuses often burn out...
•
Call the serviceman or your electrician!
Oven illumination is not on....
•
Exchange of oven bulb is described in the
section "Replacement of parts".
Oven does not heat up...
•
is the mains power fuse burned?
•
is the temperature regulator set correctly?
•
did you set the oven to the conventional mode
after using it in the automatic mode
(programmed)? Switch the mode button to the
position "Manual mode".
Baking results are disappointing...
•
did you remove the grease filter?
•
did you follow the instructions and warnings
from the section "Baking"?
•
did you strictly follow the information from the
baking table?
Replacement of parts
The oven light bulb casing is under tension.
Danger of electric shock!
Before replacing the oven bulb switch off the
cooker and cut it from mains by removing the
mains power fuse or disconnect the protective
device.
Remember that the bulb is regarded as
consumption material and is not covered by the
warranty.
Other accessories
Oven grid, biscuit tray, etc. may be ordered from
the service centre. When ordering please quote
the code and the type or model of the appliance.
Hotplate control knobs are removed by pulling
them outwards and replaced by pushing the new
ones back in place.
Oven light bulb
The bulb for replacement should meet the
following specifications:
E 14, 240 V, 25 W, 300°C.
Unscrew the glass cover by turning it counter
clockwise, and replace the bulb. Screw the glass
cover back in place.
Remember that the bulb is regarded as
consumption material and is not covered by
the warranty.
