Kleenmaid Automatic dryers, Installation Instructions Manual

Page: 13 / 28

504062
11
Electrical Requirements . . .
(Electric Dryers)
NOTE: The wiring diagram is located inside the
control hood.
IMPORTANT: The electrical installation in the site
shall comply with the latest edition of Australian
Electrical Standards, AS3000, SAA wiring rules,
and such local regulations that might apply.
This dryer is designed to be operated on a two wire,
plus earth, 240 Volt, 50 Hertz, single phase circuit,
fused at 20 amperes.
Insert the dryer’s lead-in cord plug into an earthing
three-slot-plus earth, wall receptacle on a separate
circuit. DO NOT OPERATE OTHER APPLIANCES
ON THE SAME CIRCUIT WHEN THE DRYER IS
OPERATING.
50 Hz
250 V
LEAD-IN
CORD
EARTH
SCREW
EARTH
D197IE1A
LEAD-IN
CORD PLUG