Instruction
manual
HK
12/2
page
15
__________________________________________________________________________
Attention
Before operating the unit the oil level must be checked and adjusted if
necessary.
2.) Remove the hook (Pos.-No. 2) as described above, insert the crimping dies and bring
the crimping head into a proper working position.
3.) Insert cable with connector into the head.
4.) Actuate the pump lever (Pos.-No. 1) continuously until the dies are completely closed
and the release valve responded. The crimping process proceeds as described in chapter
4.3.
5.) After the crimping cycle has been completed, the release lever responded and the piston
retracted remove the connecting material from the crimping head.
5.2. Explanation of the application range
Our hydraulic crimping tool type HK 12/2 has a large number of
various dies (Pos.-No. 7) available to crimp primarily copper and
aluminium but also other connecting material.
Table 2
Picture
3
Crimping range
Connecting material
_________________________________________________________________________________________________________
a 16-400
mm² Tubular cable lugs and connectors „Standard type“
______________________________________________________________________________________________________
b 16-240
mm² Compression cable lugs and joints DIN 46235/DIN 46267
_________________________________________________________________________________________________________
c 10-240
mm² Aluminium cable lugs and connectors
______________________________________________________________________________________________________
d 25-185
mm² Compression joints for full-tension connections for Aldrey
conductors acc. to DIN 48201, sheet 6 and Al-conductors acc. to
DIN 48201, sheet 5, 120-185 mm²
______________________________________________________________________________________________________
e 25/4-120/20 mm² Compression joint acc. to DIN 48085 part 3 for Al-/Steel cables
acc. to DIN 48204
_________________________________________________________________________________________________________
f 10-300
mm² Pre-rounding dies for Al- and Cu-Sector-conductors
_________________________________________________________________________________________________________
g 10-150
mm² Solderless Terminals DIN 46234,
Pin
terminals
DIN
46230
_________________________________________________________________________________________________________
h 10-95
mm² Insulated Terminals
_________________________________________________________________________________________________________
i 16-150
mm² Tubular cable lugs for fine-stranded conductors
_________________________________________________________________________________________________________
j 4-70
mm² C-clamps
_________________________________________________________________________________________________________
k 10-150
mm² Pre-insulated tubular cable lugs and connectors,
insulated
pin
cable
lugs
_________________________________________________________________________________________________________
l 2x50-2x95
mm² Double compression cable lugs
_________________________________________________________________________________________________________
m 25-185
mm² Cable-End sleeves
_________________________________________________________________________________________________________
n 25-185
mm² Cable-End sleeves for compacted fine stranded conductors
