27
EN
Timer
• Timer function: When the timer button is pressed, the status is displayed on the
screen and the LED indicator blinks every 0.5 seconds. You can now use the timer
button to set the time and the timer in 1-hour increments (0 - 8 hours). If the timer
button is pressed and held for longer than 2 seconds, the corresponding timer
functions change. The set value is then displayed on the screen.
•
If the button is not pressed for 5 seconds or another button is pressed within 5
seconds, the ambient temperature is automatically displayed immediately on the
screen.
• If „0“ is set as the timer value, it means that no timer has been set and the normal
display appears on the screen.
• Normal display: If no timer value has been set, the current ambient temperature is
displayed on the screen. The temperature unit is „°C“ and the temperature display
range is -10°C to 40°C. If the temperature is below -10°C, the screen will display
„LO“ and if the temperature is above 40°C, the screen will display „HI“. If the
timer has been set, the ambient temperature is first displayed on the screen for 5
seconds and then changes to the timer display, where the remaining time until the
unit is automatically turned off is displayed for 5 seconds. The unit then returns to the
ambient temperature display. These two displays change cyclically.
Swing Left and Right
When this button is pressed, the unit swings from left to right.
Air Humidification/Cooling Button
If you press this button, the humidification and cooling mode can be activated. The
corresponding display will appear on the screen.
Magnetic circuit breaker for automatic water level detection
When the cooling function is started by the appliance, the program used to check
whether there is still water in the water tank may be delayed by 45 seconds. An
additional 5 seconds are required to assess the degree of cooling. Once the cooling
function is activated, water is pumped into the water pipe, regardless of how much
water is in the water tank. This is because the magnetic circuit breaker cannot assess the
actual water level in the tank until 45 seconds have elapsed. From the 45th second to
the 50th second, the state of the magnetic circuit breaker is assessed. Depending on the
measurement of the device, the pump either continues to run or is deactivated when the
water level is too low.
