Klarstein Darjeeling 2G, Manual

Page: 8 / 24

8
• To avoid scalding, always ensure the lid is correctly positioned before operation.
• Scalding may occur if the lid is removed while heating.
• Remove and replace the lid carefully when hot.
• Extreme caution must be used when moving the kettle containing hot water. Never lift the
kettle by its lid. Always use the body handle.
• Do not switch your kettle on if it is empty.
• To protect from electrical hazard, do not immerse this kettle, power base or cord set in any liquid.
• Use the kettle only with the supplied base unit. Do not use the base unit for other purposes.
• While the water doiling or in the short time after the water boils, please be sure that don’t
attempt to open the cover for avoid the steam scalding your hand.
• Please avoid the liquid sprinkling in the LCD board and the pressed key place in the ope -
rating process. Because the water possibly can plunge in the product, causes the function
to be unusual.
• This appliance should not be used by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have are
supervised by the person who is responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
Use and Operation
Getting Started
• Before first use, fill the kettle with clean water to maximum capacity and boil. Discard the
water and repeat the process.
• The kettle should always be unplugged when filling or adding water.
• Fill the kettle with water to desired level. Do not overfill or there will be a risk of spillage
or spitting. The water level indicator will assist you to measure the correct amount. You
can fill the kettle via the spout or after opening the lid. Do not forget to close the lid af -
ter filling, otherwise the kettle will not automatically switch off after use. Do not fill with
less than 0.5 liters of water to “min” indication, to prevent the kettle running dry while
operating.
• Do not fill with less than 1.7 liters of water to “max” indication.
• An automatic safety cut-out has been fitted for protection against overheating, it will
operate if the kettle is switched on when containing insufficient water. Always ensure
the water inside the kettle covers the minimum mark on the water level indicator gauge.
• If the automatic safety cut-out has operated, switch the kettle off. Disconnect from the
power outlet and allow the kettle to cool down for 5 to 10 minutes. Then refill with and
switch on the kettle will work as normal.
• After boiling, the kettle switches off automatically.
• Disconnect the kettle from the mains electricity supply.
• Do not open the lid when pouring.