Klarstein 10030917, Manual

Page: 19 / 56

19
EN
OPERATION
Commissioning
1. Carefully remove the unit from the carton. Save the carton for storage outside of the
heating season.
2. Make sure the on/off switch is off before connecting the unit.
3. The heater must be fully assembled and mounted according to the assembly
instructions.
4. It is better not to use the same electrical connection with other power-hungry
devices to avoid overloading the circuit.
Power up
Connect the device to the power supply. Switch on the device with the On/Off key (13).
The unit is now in standby mode and the current time is displayed. The keys (13), (14),
(15) and (16) light up and go dark again after 10 seconds. Now the display shows the
current room temperature.
Time setting
Press and hold the settings (16) and the up arrow key (15) simultaneously for three
seconds. The weekly display (6) flashes and the time setting is active. Use the arrow
keys to select a day of the week. Press the settings (16) and the hour display (5) flashes.
Select the hour again with the arrow keys (14, 15). Press the settings (16) to move to the
minutes setting. Select the minute with the arrow keys (14, 15) and confirm the set time
with the settings (16).
Temperature setting
Press Settings (16). The temperature display (17) flashes. Then select the temperature with
the arrow keys (14,15). Confirm with the settings (16) or do not make any further entries
for 5 seconds so that the settings are automatically accepted.
Selecting the power level
Select the low heating level with the down arrow key (14). The symbol appears in
the display. Select the high heating level with the up arrow key (15). The symbol
appears in the display. Alternatively, press the key (21) to switch between high and low
heating level.