KKT KOLBE GS63VI, User Manual

Page: 59 / 72

59
Rinsing programs
EN
!
!
1. Press the power switch to cancel the program.
2. Turn the appliance on again. Then you can change the program to the
desired cycle setting.
The programm lights show the state of the dishwasher:
Program indicator light on: cycle running
Program indicator light flashing: pause state
Note:
If you open the door during rinsing, the appliance will pause, a war-
ning signal sounds and the first two program indicator lights flash.
When you close the door, the appliance continues to operate.
1. Hot dishes are sensitive to knocks. They should therefore be allowed to
cool down about 15 minutes before opening the door of the dishwasher.
2. As hot steam could escape, open the door carefully and leave it ajar a
few minutes before taking out the dishes. In this way they will be cooler
and the drying will be improved.
3. It is normal that the dishwasher is wet inside.
Empty the lower basket first and then upper one. This will avoid water
dripping from the upper basket onto the dishes in the lower one.
1. Open the door of the dishwasher slowly and very carefully, as hot steam
could escape. Wait until the spray arms stop working. (Risk of burns!)
2. Then you can fully open the door and put in additional dishes.
3.
Close the door. The dishwasher will continue to work after 10 seconds.
The change of the washing program should be carried out im-
mediately after the start of the program, otherwise the tablets
could be already solved or hot water may be leaking.
The additional loading of the dishes in the dishwasher is only
possible when the washing program has just been started,
before the detergent cup is opened.
4.2 Changing the rinsing program
4.4 At the end of the rinsing program
4.3 Additional loading of dishes