21
Installation and connection of the device
EN
Connection to the power supply
Foll owing cable types are suitable for the device:
H05 RR-F , Min 1.1m 3x 2.5mm
2
During this operation, the appliance must be
disconnected from the mains!
• Remove the cover from the bottom right of the rear panel
by loosening the two clamp screws. Remove the two
screws on the strain relief clip to the right of the terminal
block.
• Pull the replacements mains cable. Lower the outer jacket
of the new pipe to the appropriate length.
• Remove about 12 mm wide and press on end sleeves on in-
dividual wires insulation. Insert the new cable through the
opening provided in the rear wall and through the strain
relief clamp. The outer covering of the cable is in the strain
relief clamp on the side of the terminal block to go through
at least 1 to 2 mm.
• Then tighten the two screws of the clamp.
• Check the effectiveness of the strain relief by pulling on the
line in an appropriate intensity.
Connect the wires to each terminal in the following way:
Connection L – brown wire / phase
Connection - green/gelbe wire / ground
Connection N - blaue Ader / neutral
• Tighten the connector screws securely and check by gently
pulling on each wire if the wire was reliably detected by the
terminal.
• Cover mount with two screws. When the oven is connected
to the power supply by a plug, this must remain accessible
after installation.
• We accept no liability in case of accident by non-existent or
for defective grounding.
Safety notes:
After replacing, perform the power cord safety
test according to VDE 0701!
phase
ground
neutral
!
!
From the factory, the unit is shipped with a
standard EURO-plug device.
