- 10 -
Troubleshooting
What if ...
... on the display of the electronic controller the
error F is shown?
•
The regulation found an error in the program
sequence. The meaning of the error and its correction
are described in the controller users manual.
... if the firing chamber does not heat up?
Possible causes are:
•
The lid is not closed completely. Then the safety
switch could be activated to switch the kiln off. The lid
should be adjusted by your service engineer.
... the firing chamber heats too slow or the kiln
does not reach the set temperature?
•
One or more heating elements are defective. Firstly,
check the elements visually for breaks.
•
If you cannot find a break, flow of current through the
elements can be checked with a suitable meter.
Broken heating elements should be changed by your
service engineer.
•
The voltage supply to your kiln could be below 230V.
This can be checked by your service engineer.
... the glaze did not melt enough or the kiln
switched off before reaching the set temperature?
•
Power failure during the firing
•
Lid was not fully closed
If you are still unable to locate the error despite these
tips please get in contact with your service engineer or
with our service department.
The
Kittec
address can be found on the warranty
certificate page 13.
