3
GAS CONVERSIONS
Tools and Parts
Gather the required tools and parts necessary for correct LP gas
conversion.
Tools needed
■
¹⁄₈
"
Flat-blade screwdriver
■
#2 Phillips screwdriver
■
#20 Torx
†
screwdriver
■
⁹⁄₃₂
" (7 mm) nut driver
■
Wrench
■
Masking tape
Parts supplied
■
LP orifice package
■
Conversion instructions
■
Conversion label
IMPORTANT:
Gas conversions must be done by a qualified
installer. Before proceeding with conversion, shut off the gas
supply to the cooktop prior to disconnecting the electrical power.
Convert from Natural Gas to LP Gas
1.
Turn manual shutoff valve to the closed position.
2.
Unplug cooktop or disconnect power.
To Convert Gas Pressure Regulator
†®TORX is a registered trademark of Acument Intellectual Properties, LLC
WARNING
This conversion kit shall be installed by a
qualified service agency in accordance
with the manufacturer's instructions and
all applicable codes and requirements of
the authority having jurisdiction. If the
information in these instructions is not
followed exactly, a fire, explosion or
production of carbon monoxide may
result causing property damage, personal
injury or loss of life. The qualified service
agency is responsible for the proper
installation of this kit. The installation is
not proper and complete until the
operation of the converted appliance is
checked as specified in the
manufacturer's instructions supplied with
this kit.
A. To cooktop
B. Shutoff valve (closed position)
C. Gas supply line
A. Access cap
B. Rear of cooktop
C. Gas pressure regulator
D. Gas flow
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
A
B
C
A
B
C
D
