KitchenAid KVUC606J55, Installation Instructions And Use & Care Manual

Page: 10 / 32

10
3.
Use UL listed wire connectors and connect black wires (B)
together.
4.
Connect green (or bare) ground wire from home power
supply to yellow-green ground wire (C) in terminal box using
UL listed wire connectors.
5.
Install terminal box cover.
6. Check that all light bulbs are secure in their sockets.
7.
Reconnect power.
Install Vent Covers (Optional)
If you are installing an optional full width duct cover, follow the
instructions included with that product.
Complete Installation
1.
Install metal grease filters. See the “Range Hood Care”
section.
1. Check the operation of the range hood blower and light. See
the “Range Hood Use” section.
NOTE: To get the most efficient use from your new range hood,
read the “Range Hood Use” section.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after
the cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located on the underside of the range
hood.
Range Hood Controls
Operating the light
1.
Move the light switch to the “1” position to turn range hood
light to night light setting.
2. Move the light switch to the “2” position to turn range hood
light to full light setting.
3. Move the light switch to the “Off” position to turn range hood
light OFF.
IMPORTANT:
Flicker and visual fluctuation can be present
every time the lamp switch is activated. The duration of the
flicker will depend on the manner and velocity that the light
switch changes position.
Operating the fan
1. Move the fan switch to the “On” position to turn the fan
ON. The fan will begin operating at the speed set on the fan
speed switch.
2.
Move the fan switch to the “Off” position to turn the fan OFF.
Auto On Fan
The range hood is equipped with a sensor to automatically
turn on the fan when excessive heat is detected in the control
area. When the fan switch is in the “Off” position, this sensor
will turn the fan to high speed when necessary. When the heat
decreases, the fan will turn off.
When the fan switch is in the “On” position, the heat sensor is
not active and the range hood functions normally.
Adjusting the fan
The fan has 3 speed controls. Move the fan speed switch to “1”
position for low speed, “2” position for medium speed, or “3”
position for high speed.
Thermal Protector
The range hood is equipped with a thermal protector to avoid
overheating conditions. If the range hood shuts off while in use,
move fan slider switch to Off to turn off the range hood. Wait
approximately 60 minutes, then move slider to On to restart the
range hood.
A
B C
A. Light control
B. Blower control
C. Fan speed control