![background image](http://html.mh-extra.com/html/kitchenaid/kfgg500ewh/kfgg500ewh_owners-manual_198253008.webp)
8
INSTALLATION INSTRUCTIONS
REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
�
Tape measure
�
Flat-blade screwdriver
�
Phillips screwdriver
�
1/8" (3.2 mm) flat-blade
screwdriver
�
Level
�
Hand or electric drill
�
Hammer
�
Wrench or pliers
�
Pipe wrench
�
15/16" combination wrench
�
1/4" drive ratchet
�
3/8" nut driver
�
1/8" drill bit (for wood floors)
�
Marker or pencil
�
Pipe-joint compound
resistant to Propane gas
�
Noncorrosive leak-detection
solution
�
3/16" (4.8 mm) carbide-
tipped masonry drill bit
(for concrete/ceramic floors)
(For Slide-in/Front Control
Ranges)
For Propane/Natural Gas
Conversions
�
3/8" combination wrench
�
1/2" combination wrench
�
5/8" combination wrench
�
9/32" nut driver
�
Quadrex
®
†
or Phillips
screwdriver
�
Masking tape
�
3/8" nut driver
(For Slide-in/Front Control
Ranges)
Parts Supplied
Check that all parts are included.
A. Anti-tip bracket
B. #12 x 1
5
/
8
” (4.1 cm) screws (2)
Anti-tip bracket must be securely mounted to floor or wall.
Thickness of flooring may require longer screws to anchor bracket
to floor.
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See “Electrical Requirements” and
“Gas Supply Requirements” sections.
NOTE:
Be sure to purchase only whirlpool factory-certified parts
and accessories for your appliance. Your installation may require
additional parts. To order, refer to the contact information
referenced in your Quick Start Guide.
Location Requirements
IMPORTANT:
Observe all governing codes and ordinances. Do
not obstruct flow of combustion and ventilation air.
�
It is the installer’s responsibility to comply with installation
clearances specified on the model/serial/rating plate. The
model/serial/rating plate is located behind the oven door on the
top right/left-hand side of the oven frame.
�
The range should be located for convenient use in the kitchen.
�
Recessed installations must provide complete enclosure of the
sides and rear of the range.
�
All openings in the wall or floor where range is to be installed
must be sealed.
�
Cabinet opening dimensions that are shown must be used.
Given dimensions are minimum clearances.
�
The
anti-tip
bracket
must
be
installed.
To
install
the
anti-tip
bracket
shipped
with
the
range,
see
“
Install
Anti-Tip
Bracket
”
section.
�
Grounded
electrical
supply
is
required.
See
“
Electrical
Requirements
”
section.
�
Proper
gas
supply
connection
must
be
available.
See
“
Gas
Supply
Requirements
”
section.
�
Contact
a
qualified
floor
covering
installer
to
check
that
the
floor
covering
can
withstand
at
least
200°F
(93°C).
�
Use
an
insulated
pad
or
1/4"
(6.4
mm)
plywood
under
range
if
installing
range
over
carpeting.
IMPORTANT:
To avoid damage to your cabinets, check with your
builder or cabinet supplier to make sure that the materials used
will not discolor, delaminate or sustain other damage. This oven
has been designed in accordance with the requirements of UL
and CSA International and complies with the maximum allowable
wood cabinet temperatures of 194°F (90°C).
Mobile Home - Additional Installation
Requirements
The installation of this range must conform to the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction and
Safety, Title 24, HUD Part 280). When such standard is not
applicable, use the Standard for Manufactured Home Installations,
ANSI A225.1/NFPA 501A or with local codes. In Canada, the
installation of this range must conform with the current standards
CAN/CSA-Z240.1 - latest edition, or with local codes.
Mobile Home Installations Require:
�
When this range is installed in a mobile home, it must be
secured according to the instructions in this document.
†
®
QUADREX is a registered trademark of NLW Holdings, Inc.
Summary of Contents for KFGG500EWH
Page 52: ...Remarques 52 ...
Page 53: ...53 Remarques ...
Page 54: ...Remarques 54 ...
Page 55: ...55 Remarques ...