2-4
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
REMOVING THE CONTROL POWER AND LAMP
TRANSFORMERS, THE ELECTRONIC RANGE CONTROL,
THE OVEN DOOR LATCH ASSEMBLY, & SPARK MODULE
1.
Turn off the gas and electrical power going
to the range.
2.
Remove the grates, burner caps, and
burner heads from the cooktop (see page
2-2).
3.
Remove the cooktop from the range (see
page 2-2).
CAUTION:
When you work on the dual fuel
range, be careful when handling the sheet
metal parts. Sharp edges may be present, and
you can cut yourself if you are not careful.
WARNING
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
4.
Starting from the front, peel off the rubber
tape from around the top access panel.
NOTE: Carefully peel the tape off as one
continuous piece, and do not allow the
adhesive sections to stick together.
5.
To remove the access panel, remove the
four screws, raise the back, and unhook
the panel from the front.
Unhook Panel
& Slide Off At Back
Top Access
Panel Screws
Peel Off
Rubber
Tape
BACK
