KisanKraft
®
Agricultural Inter-Cultivator
KK-IC-650D
: +91.80. 6835 7800
Page 15 of 49
and side fender have been installed to the machine after unpacking, this step can be omitted)
5. Check the whole machine, see if there are no missing parts and other missing parts in the accessory box,
and then follow the instructions to perform the next steps
Operation Instructions
Before sending the weeder out of factory, adjusting and debugging is done, for comfortable and easier
using, the user should inspect and adjust it again.
◆
1. Daily Checking
1.1 Check all the bolts in the connecting part ensure all of them are tightening.
1.2 Checking the handles (throttle, Clutch and gear shifting lever), make them flexible and in the
correct position.
1.3 Put the shift lever in the neutral gear place.
1.4 Add oil:
a.
Add lube oil () to crankcase as Photo III shows.
b.
Put the engine at horizontal position. Insert the dipstick into the filler neck without
screwing it in. Get the dipstick out, check the oil level. The oil level should be the
mentioned position in the dipstick. (Look at Photo III).
c.
Refuel air cleaner with oil, disassembling the synthetic glass cover tent below the
cleaner, and refuel 0.1L No.20 oil.
1.5 Add fuel;
1.6 Make preparation following the user manual before starting machine.
△
! Attention
Don’t rotate dipstick, don’t add lube oil between upper level and
lower level.
◆
2. Weeder adjustment
△
! Attention
Please put the Intercultivator on firm land level before adjusting the
handle height to prevent the handle from collapsing accidentally.
