KisanKraft
®
Agricultural Portable Sprayer (Power)
KK-P767/ P768/ P769/ P780, KK-TPS-60T
Agricultural Knapsack Sprayer (Power)
KK-707/ 708/X/AL, KK-KPS-162 / 802
This warranty is null & void, if you fail to register the warranty with KisanKraft
by
sending the KisanKraft Copy with dealer’s stamp.
: www.kisankraft.com
: +91.80. 6835 7800
KK-P767/ P-768 / P769 / P780 & KK-TPS- 60T:
3.
Pull the recoil starter lightly 2-3 times.
4.
Pull the recoil starter strongly to start the engine.
5.
If the engine stops after a few revolutions, set the choke to half open, and pull the recoil
starter rope strongly again to restart it.
Note
: If the engine does not catch even after the starter is pulled several times, set the
choke lever to full open and pull the starter rope. Be sure not to pull the starter lever
completely out. After the engine starts, open the choke lever slowly, move the throttle
lever to the low
–speed side, and let the sprayer warm up for 2-3 minutes.
Pull briskly:
KisanKraft
®
2 - STROKE PETROL ENGINE
: www.kisankraft.com
: +91.80. 6835 7800
Page 37 of 48
ADJUSTING THE CARBURETOR
Engine revolution speed is adjusted at the optimum condition before shipping
from the factory. It should be adjusted only when it fails to operate properly. (Consult
your dealer when adjustment is necessary.)
1.
Use the slow speed adjusting
screw to adjust the slow speed
revolutions.
•
Right turns: Increase the
revolution speed.
•
Left turns: Slow down the
revolution speed.
Increasing the slow revolution
excessively causes the driven
equipment unable to stop
even if the throttle lever is
returned.
The
revolution
speed should not be increased
excessively.
2.
In case with the slow speed
fuel adjusting screw Normal
position is where it is returned
by one turn from the fully
closed position (right turn).
•
Right turns: Increase the
thickness of fuel.
•
Left turns: Decrease the
thickness of fuel.
3.
In case with the high speed fuel
adjustment screw
•
Right turns: Decrease the
thickness of fuel.
•
Left turns: Increase the
thickness of fuel.
Fuel adjustment for the
carburetor is completed at the
optimum
condition
before
shipping from the factory.
When it is necessary to adjust,
consult your dealer.
Do not decrease the thickness
of fuel too much.
(It could result in the seizure
trouble of engine.)
Slow Speed
Adjusting Screw
Slow speed fuel
Adjusting screw
High speed fuel
adjusting screw
