Page 7
•
Drill the 4 mounting holes and place the Inverter in position and fasten the unit to the mounting
surface.
Chassis Grounding Connection:
DANGER:
The unit chassis has to be grounded properly. Never operate the Inverter
without proper grounding. Failure to do so will result in death or serious injury.
•
Connect the grounding cable’s ring terminal to the unit ground screw.
•
Connect the other side of the cable to the common grounding point.
Important: Field wiring DC terminals tightening torque 12-13 Nm.
DC Input Connection:
CAUTION
: Reversing the DC Input terminal will damage the unit and it cannot be repaired.
Damage caused by reverse polarity connection is not covered by the warranty.
•
Connect one end of the negative DC input cable to the Inverter DC negative terminal. Connect
the other end of the cable to the battery negative terminal.
•
Make sure the Disconnect Switch is in the OFF position.
•
Connect one end of the positive DC input cable to the Power Inverter DC positive terminal.
•
Connect the other end of the positive DC input cable to one of the terminals of the Disconnect
Switch.
•
Connect a DC input cable between the other terminal of the Disconnect Switch and one side of
the terminal of the fuse holder.
•
Connect a DC input cable between the other terminal of the fuse holder and the battery positive
terminal.
•
Install the selected fuse to the fuse holder.
•
Turn Disconnect Switch to ON position.
AC Output Connections:
CAUTION: P
lease be sure that the DC disconnect switch is turned OFF.
The AC Output has two types of AC connections:
1)
Use of the provided AC sockets – NEMA 5-20 (Port 1 and 2) for AC load:
This configuration does not require AC Output installation. Plug in the AC load to the provided
AC output sockets. Each AC output port (Port 1 and 2) is limited to 20A and each port is
protected by it’s 20A supplementary breaker.
2)
Use of the provided Hardwire AC Output terminal (Port 3).
•
Remove the 4 screws that secure the AC compartment cover located on the front panel of
the unit.
•
Hardwire the AC load or any external AC socket to the AC Output ports 3. Please verify
the Line ‘L’ and NEUTRAL ‘N’ connection on the AC Output ports. The AC Output port can
provide the maximum power of 3000W, 25A AC current.
•
Re-install the AC compartment cover.
