9
INSTALLATION
INSTALLATION
STEP 4: Connect the Power Source
NOTE:
When power is connected to the motor, a blue LED inside the control button housing will flash twice to indicate the shade
is ready for operation.
■
Refer to the appropriate page based on your order.
➤
For an optional attached battery wand, see below.
➤
For a satellite battery pack, see page below.
➤
For an optional headrail-mounted rechargeable battery wand, see page 10.
➤
For an optional satellite-mounted rechargeable battery wand, see page 10.
➤
For an optional 18V DC Power Supply, see page 12.
➤
For two battery wands and a double connector power cable, see page 12.
➤
For an optional 18V DC Power Supply with daisy-chain connections, see page 13.
➤
For an optional C-size satellite battery wand or large DC supply, see the instructions that came with the wand.
Attached Battery Wand
Plug the Power Cable into the Battery Wand
■
Snap the battery wand into the battery wand clip on the back of the cassette.
■
Connect the power cable from the motor to the battery wand.
Proceed to “Testing the Shade” on page 13.
Satellite Battery Pack
■
Decide where you want to mount the bracket(s). A satellite battery pack may be mounted in any orientation.
■
Mark the screw holes.
■
Drill the screw hole using a
3
⁄
32
" drill bit.
■
Attach the installation brackets using the screws provided.
■
Position the battery wand or double connector power cable (if used) so the power cable is
easily connected.
■
Snap the battery wand into the bracket.
Brackets removed for clarity.
Battery Wand
Battery Wand Clip
Power Cable
Bracket for the
Satellite Battery Pack
Socket
