KIRLOSKAR KPDS, Instruction On Installation, Operation And Maintenance

Page: 17 / 50

IOM/KPDS/NOV 19/00
Page 14 14 14 14 of 50 50 50 50
Issue Date : 22/11/2019
Revision: 00
10.6 Fit adapter to casing cover and tee joint to bearing spider (if applicable). Connect
the transmission bearing flushing pipe to adapter with the help of nuts. (Applicable
if transmission bearing lubrication is external clear compatible liquid, otherwise fix
plug to the casing cover).
10.7 Fix the clamp to the bottom column pipe (13301).
10.8 Lift the unit vertically with the help of slings and chain pulley block. While lifting
take care that no part of the pump is being dragged against the floor.
10.9 Put two girders or strong wooden logs across the opening of the tank in which
pump is to be fitted. Rest the clamp while erecting the pump. Lower the unit till the
clamp rests on the girders.
10.10 Press the intermediate bearing bush (35100) in bearing spiders (24500) then drill
and tap (M6x10L) one hole at the junction of bush and bearing spider. Fit one grub
screw in the tapped hole to avoid the rotation of bush (This is required in case of
replacement of bush only). Mount cover (27801) on bearing spider with the help of
screws. Fix non-metallic screw on bearing spider to avoid the rotation of bush.
10.11 Mount bearing spider (24500) on the bottom column pipe (13301).
10.12 Mount standard column pipe (13302) on bearing spider (24500). Fix it with the help
of screw and nuts. Tighten the diametrically opposite nuts one by one. Fix three
way pieces to the bearing spider (24500) and connect the flushing pipe coming
from casing cover (22000). Also fix one more flushing pipe to another end of three
way piece with the help of sealing nut.
10.13 Apply thread compound liberally inside the screwed coupling (39500) fitted on
the pump shaft and threaded portion of intermediated shaft (18400). Fit the
successive screwed coupling in to intermediate shaft (18400) and intermediate
shaft in to the screwed coupling already fitted on the pump shaft (18600).
10.14 Lift the column pipe (13302) with the help of another clamp.
10.15 Lower the standard column pipe (13302) and fix to the lower column pipe (13301)
with the bearing spider in between. Tighten the diametrically opposite nuts one by
one.