13
12
you to ignore (not hear) calls from other irrelevant parties who are
using the same channel. When you receive a signal that has a tone
different from the one set on your radio, you will not hear the signal.
Likewise, signals that you transmit will only be received by parties
whose QT/DQT tones are the same as yours.
Note:
* Using a QT/DQT channel doesn’t mean your calls are private. If
other parties’ QT/DQT tones are identical with yours, they can hear
your calls.
* Set the battery saving mode to be “Off” or “1:1” if the QT/DQT
decoding time is long.
Talkaround
You can expand the communication range of your network through a
repeater. If the radio is out of the communication range, you can
connect with other radios through “Talkaround” mode.
Press the preprogrammed “Talkaround” button to switch between
“Talkaround” mode and “Repeater” mode.
Scan Function
In order to receive calls from many different channels, the radio can
be programmed to scan these channels.
Starting/Stopping Scan
a) Press the button set as “Scan” to start scanning.
While in
scanning, the radio checks every channel in the scan list and stops
on which a signal is detected until that signal disappears. If interval
between signal disappearing and continuing scanning has been
preset, the radio will remain on that channel.
b) Priority Scan:
One channel in the scan list can be set as the priority channel,
which enables it to have the highest priority during scanning. The
radio will scan a non-priority channel firstly, then the priority
channel, and then the next non-priority channel, and then the
priority channel again, and the scan goes on like this.
If the priority channel and the “lookback time” have been set for the
scan list, when the radio is receiving signals on a non-priority
channel, and the scanning is paused, the radio will check the
priority channel at the preset intervals. If there are signals in the
priority channel, it will stay at the priority channel; if there is no
signal, it will return to the original channel.
c)
The revert channel (Tx channel) during the scan can be
designated by the dealer. There are following options available:
Selected Channel:
When pressing the PTT button, the radio will
transmit from the first channel of the scan list.
Selected C Currently Working Channel:
When pressing
the PTT button during scanning, the radio will always transmit from
the first channel in the scan list. When pressing the PTT button
during the scanning pause, the radio will always transmit from the
currently working channel.
Priority Channel:
The radio will transmit from the priority channel in
