and the charger is in the protected status, in which you should not charge the battery compulsorily.
Please remove the battery and cut the power of the charger.
Note:
* The radio battery has not been charged when leaving the factory; please charge the battery
before using the radio for the first time.
* Both KB-56A lithium polymer battery and KB-56B lithium polymer battery of the company are
applicable to this radio.
* Charge the battery for several times for the first charging after purchase or after the radio is laid
aside for a long time (longer than 2 months), so that the battery can reach its normal battery
capacity. Meanwhile, please make sure to charge the battery at least once every three months.
* It is better not to recharge the battery if the battery is fully charged or the radio is not in its low
battery alarm status; otherwise, the battery’s service life and performance may be influenced. After
the battery charging is finished, please remove it from the charger.
* When the radio enters the low battery alarm status, please recharge the battery before reusing it.
Do not turn on the radio compulsorily; otherwise, the service life and performance of the battery
may be influenced.
* KB-56A/KB-56B battery is provided with internal protective circuit. When the battery power is
too low, the battery will cut the power supply automatically. If it is charged on the charger now,
the red LED will not be on immediately. After about 1 to 5 minutes, the charging indicator will
turn normal.
2.2 Install/Remove the battery
Install the battery:
Align the two protrusions at the upper end of the battery to the slots at the upper end of the
shell of the radio and insert them.
Press the lower end of the battery down until the latch of the radio completely bounces out,
and the battery is locked.
Remove the battery:
