Low oil alarm indicator
light (red)
Low oil alarm system
The Low oil alarm system is designed to prevent engine damage caused by an
insufficient amount of oil in the crankcase. Before the oil level in the crankcase
falls below a safe limit, the Low oil alarm system will automatically shut down the
engine (the engine switch will remain in the ON position).
If the low oil alarm system shuts down the engine, the low oil alarm indicator
light(red) will come on when you operate the starter, and the engine will not run.
If this occurs, add engine oil.
20
17
4.Switch on the equipment to be used.
In case of overload operation or when trouble occurs for the equipment being
used, the output indicator light(green) will go out, the overload indicator light(red)
will light continuously, and no power will be put out.
At this time, the engine will not stop, so that the engine must be stopped by
setting the respective engine switch to STOP.
When equipment requiring a large starting power, like a motor etc., is used,
the overload indicator light (red) and the output indicator light(green)may
light together for a short time (about 4 sec), but this is no abnormality. After
start of the equipment, the overload indicator light (red) will go out and the
output indicator light(green) will stay lit.
CAUTION
In DC operation, turn the Smart throttle switch to the OFF position.
NOTE
The DC receptacle may be used for charging 12 volt automotive-type batteries
only, the zero load voltage is 15V-30V.
DC output will vary according to the position of the smart throttle switch.
