4.2 Limit switch adjusting
4.2.1 Loosen the left and right lock bolts by a cross head screw
-driver, at the same make sure the gear pins don’t touch
the micro switch.
4.2.2 Turn on the power, and make the motor run, confirm the
status of the rolling pipe, is it rolling up or rolling down.
4.2.3 When the electric film reeler is rolling up the plastics, rotate
any of the knobs slowly, and make the gear pin touch the
micro switch ( with click sound) , if the motor stops running,
it means this knob is used for the rolling you need; if the
electric film reeler doesn’t stop running, then the other
knob is used to control the required rolling.
4
、
LIMIT RANGE ADJUSTING
4.1 Limit illustration
Before limit adjust, please loosen“left or right fasten bolts”
After limit adjust, please fasteb“left or right fasten bolts”
CAUTION: After the limit adjust is finished, please fasten the bolts. Or the
limit will not be accurate and there would be dange of power shock.
8
Left gear pin
Left lock bolt
Left knob
Right gear pin
Right lock bolt
Right knob
Micro switch
2.3. Circuit principles
24V Power Supply
Control Switch
Power Supply For Electric film reeler
24V DC
Motor
Connecting Diagram
3
