22
INSTALLING – Burner Systems and LOGF24 Logs
FIGURE 14 – Log Placement
WARNING
The positioning of the logs is critical for the safe
and clean operation of this heater. Sooting and other
problems can occur if the logs are not properly and
firmly positioned in the heater. Never add additional
logs or embellishments such as pine cones, vermiculite,
volcanic rock or rock wool to the heater.
MAIN LOG LOCATOR PINS
52” Burner System
(58-18 x 1/2 DT Screw)
Burner pan mounting
screws mount 2 on
either side of pan and 1
front center into firebox
bottom.
CROSSOVER LOG
MAIN LOG ASSEMBLY
FRONT LOG
MAIN LOG LOCATOR PINS
33/36 Burner System
MAIN LOG LOCATOR PINS
GLVF Burner System
GAS INLET
GLVF BURNER SYSTEM ATTACHMENT HOLES
(68-18 x 1/2 DT Screw)
Burner pan mounting screws Mount 2 on
either side of pan into firebox and 2 must
be mounted into fan shield.
3 PIECE LOG SET
CROSSOVER LOG
RETAINER PINS
4 PIECE LOG PLACEMENT
1. Place Front main Log on locator pins
2. When installing 4 piece log set with rear log separate
position rear main log on rear log holder located on rear
of Firebox and position locking tabs of rear log onto
locking tabs of front main log.
3. Place crossover log on retainer pins located on top of rear
main log.
4. Front log, position flat surface up to main log.
SERIAL NUMBER
WARNING LABELS
4 PIECE LOG SET
CROSSOVER LOG
REAR MAIN LOG
FRONT MAIN LOG
FRONT LOG
LEFT AND RIGHT TABS
LOCATED REAR OF
FRONT MAIN LOG
THIS TAB WILL REST ON
TAB LOCATED ON REAR
OF FRONT MAIN LOG.
CROSSOVER LOG
RETAINER PINS
Kingsman Replacement Log Listing
Reference
Part
Number
Number
Description
1
24F-A
Front Main Log A, LOGF24
2
24F-B
Rear Main Log B, LOGF24
3
24F-C
Front Log C, LOGF24
4
24F-D
Crossover Log D, LOGF24
4
2
1
3
Warning:
Failure to position parts in accordance with these diagrams or failure to use only part specifically
approved with this heater may result in property damages or personal injury.
